Re: Servos, Drivers etc. - prices

I have seen some used servos and passed them buy as they were always
too large, some with one inch shafts...


I assumed that since so many of us start out on steppers that servos
were not only a step up on performance, but a step up in costs.

Has anyone done simple cost comparison between servos and stepers ?

to the motors and drivers cost less, cost more, or about the same as
steppers ?

I should claify and talk about the larger stepper sizes, say for a
mill conversion and not a PCB etcher.

Dave

> Just a note, I can supply these motors for US$150ea + shipping,

which is

> from Australia so its probably cheaper to buy them on your end.