CAD CAM EDM DRO - Yahoo Group Archive

Re: RPM speed SOT

Posted by cnchomeman
on 2003-07-18 15:31:09 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Kenneth Emmert"
<mds1878@c...> wrote:
> Using servo's on a router/engraver and need to know
> what max travel speed to set for. These are geared
> units with a max out put of a 150 rpm. Horsepower is
> rated at 1/11, 4.6 amp 24 volt. Ball screw is 4 tpi
> and table travel is 13" x 26". Should I up gear 2 or 3
> times?
>
>
> Ken
> Kenneth A. Emmert

I would go 3 at least, maybe 4.

Eric

Discussion Thread

Kenneth Emmert 2003-07-18 15:26:52 UTC RPM speed SOT cnchomeman 2003-07-18 15:31:09 UTC Re: RPM speed SOT cnchomeman 2003-07-18 15:35:01 UTC Re: RPM speed SOT