Re: RPM speed SOT

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Kenneth Emmert"
<mds1878@c...> wrote:

> Using servo's on a router/engraver and need to know
> what max travel speed to set for. These are geared
> units with a max out put of a 150 rpm. Horsepower is
> rated at 1/11, 4.6 amp 24 volt. Ball screw is 4 tpi
> and table travel is 13" x 26". Should I up gear 2 or 3
> times?
>
>
> Ken
> Kenneth A. Emmert

Another option is to remove the geabox and then gear down 2 or 3 to
one.

Eric