Multiple stepper motor drivers and software
Posted by
Scott Riddle
on 2003-07-20 10:43:11 UTC
I am looking at 3 seperate motor/driver/power supplies to control a 3
axis mill. Will I need an extra board for the software to talk to
each driver giving it step and direction or does most software
packages use specific pins on the parallel port connection and I
would just wire them to each driver? I have seen many of the 3 or 4
axis driver boards and that sparked this question when I saw these 3
seperate motor/driver/power supplies offered on Ebay.
Thanks
Scott
axis mill. Will I need an extra board for the software to talk to
each driver giving it step and direction or does most software
packages use specific pins on the parallel port connection and I
would just wire them to each driver? I have seen many of the 3 or 4
axis driver boards and that sparked this question when I saw these 3
seperate motor/driver/power supplies offered on Ebay.
Thanks
Scott
Discussion Thread
Scott Riddle
2003-07-20 10:43:11 UTC
Multiple stepper motor drivers and software
Harvey White
2003-07-20 11:17:12 UTC
Re: [CAD_CAM_EDM_DRO] Multiple stepper motor drivers and software