RE: [CAD_CAM_EDM_DRO] Re: New mill

> -----Original Message-----
> Thanx Tim. Do you have any contact info for the fellow with the
> servos?
>
> In its current state the mill runs fine with the stock steppers and
> API-CMD 260's (that I bought from you - they are SUPER drives) but
> the machine is capable of so much more than the stock steppers can
> provide -its a shame to leave them on the machine. I think I can
> easily get 400ipm rapids with good servos and Gecko drives.

I don't have his info handy, but Les is a member of this group and a
pretty frequent poster. If you search the archives you can probably find
him.

I am not sure if I would run a series II at 400 ipm. May be a little
hard on the machine as it was never designed for that type of speed.

Tim
[Denver, CO]
Sherline & Taig products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
e-mail me at Timg @ KTMarketing.com for items not yet listed