E-stop circuit scheme.
Posted by
mrgamber
on 2003-08-03 12:57:22 UTC
I have the "charge-pump safety circuit" for Mach1/2 software built
into my controller. It turns on a relay control upon software start.
I have a SSR connected to this that switches the AC to the motor
power supply.
Question;
I plan on connecting an E-stop switch on the + wire from the break-
out board with the relay control and the SSR. This would cut the
control power (DC) and force the SSR to shut off the motor power.
Good design?
into my controller. It turns on a relay control upon software start.
I have a SSR connected to this that switches the AC to the motor
power supply.
Question;
I plan on connecting an E-stop switch on the + wire from the break-
out board with the relay control and the SSR. This would cut the
control power (DC) and force the SSR to shut off the motor power.
Good design?