Re: Yeager CNC Pro and relay settings

Hi!
I am using the same setup almost and I could not get my solenoid to
work without the pull up resistor, after putting the resistor in it
works a charm.
Mark

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shelbyshepherd2002"
<cabrillo_shepherd@m...> wrote:

> Hi all,
>
> I need some help on the settings within CNC pro for a solid state
> relay to activate a solinoid.
> It is using pin 1 to the neg on the relay and 5 volt to positive
> from games port, should it be set on high or low?
> This is the sample G code I used to test with but the relay did

not

> appear to work.
>
> G01 X5 Y5
> M01 (to turn on)
> M0 (to turn off)
> X0 Y0
>
> Any ideas welcome on settings or a sample G code to test with.