Re: EMC - M codes pause motion?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<davemucha@j...> wrote:

> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "foxprints2003"
> <foxprints2003@y...> wrote:
> > In EMC m-codes cause the interpreter to pause motion, example:
> >
> > g02x30y30i30j0f300
> > g02x0y0i0j-30m7(or m8,m3,m4 etc.)
> > EMC executes 1 quadrant arc, pauses motion, turns on M code

output,

> > resumes motion to complete arc.
> > If the M code is removed the motion is executed seamlessly.
> >
> > I need to be able to turn outputs on/off on-the-fly, Is it

possible

> > to setup EMC to allow M code output on-the-fly?
> >
> > Thanks,
> > Dean
>
>
> Are you talking like an interupt ?
> or a pause at the end of a line ?
>
> I have used a pause where I need to kit a key let software do the
> next line. I use it for testing paths and for tool changes.
>
> Dave

No, it stops all motion executes the M code & resumes, I need it to
execute the M code without stopping so i can have a lead in then
turn on the output while in motion.
-Dean