Re: EMC - M codes pause motion?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "doug98105"
<doug.rasmussen@c...> wrote:

> Mcodes.....
>
> Controls have a priority sequence in executing commands on the same
> line, "M's" usually are done prior to motion commands. The line in
> question should execute the M07 then the arc. Typically there is

no

> delay on "M's" since most of the functions being controlled via the
> Mcode have no method of feedback indicating completion.

What about M06, typically? ;-)

Fred Smith - IMService