CAD CAM EDM DRO - Yahoo Group Archive

Re: dinky microstepping driver ?

on 2003-09-07 14:54:41 UTC
I would be very interested too.

Dave



--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mariss Freimanis"
<mariss92705@y...> wrote:
> Hi,
>
> I have been following this thread for a while. It seemed
interesting
> so I drew up a schematic for a linear amplifier microstepping drive
> power section. It would be good for up to 2-3A and from 12 to
50VDC.
> A PIC or Basic Stamp wizard would have to come up with the drive
> signals.
>
> I have no interest in manufacturing it. If anyone wants to build
it,
> I can formalize the circuit in a .pdf format from my hand drawn
notes.
>
> Mariss
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
> <davemucha@j...> wrote:
> > Hi all,
> >
> > I want to move my EDM electrode with a NEM17 stepper from an old
> > floppy disk unit. am I asking too much to get a 1 amp
> microsteppping
> > driver ?
> >
> > Both the Gecko and Xylotex have lower limits on current, so that
> > might not be useable.
> >
> > any ideas ?
> >
> > Dave

Discussion Thread

turbulatordude 2003-09-06 19:25:42 UTC dinky microstepping driver ? Jon Elson 2003-09-06 21:30:34 UTC Re: [CAD_CAM_EDM_DRO] dinky microstepping driver ? ballendo 2003-09-07 01:44:19 UTC Re: dinky microstepping driver ? turbulatordude 2003-09-07 09:26:14 UTC Re: dinky microstepping driver ? Linistepper jeffalanp 2003-09-07 10:05:47 UTC Re: dinky microstepping driver ? Mariss Freimanis 2003-09-07 12:14:31 UTC Re: dinky microstepping driver ? Tony Jeffree 2003-09-07 12:34:15 UTC Re: [CAD_CAM_EDM_DRO] Re: dinky microstepping driver ? turbulatordude 2003-09-07 14:54:41 UTC Re: dinky microstepping driver ? Harvey White 2003-09-07 15:27:23 UTC Re: [CAD_CAM_EDM_DRO] Re: dinky microstepping driver ? ballendo 2003-09-08 06:44:19 UTC Re: dinky microstepping driver ? Linistepper turbulatordude 2003-09-08 09:21:12 UTC Re: dinky microstepping driver ? Linistepper James Stevens 2003-09-08 09:52:41 UTC Re: [CAD_CAM_EDM_DRO] Re: dinky microstepping driver ? Raymond Heckert 2003-09-08 11:27:39 UTC Re: [CAD_CAM_EDM_DRO] Re: dinky microstepping driver ? Jeff Jones 2003-09-09 07:44:17 UTC Re: [CAD_CAM_EDM_DRO] Re: dinky microstepping driver ? shroffja 2003-09-10 07:33:45 UTC Re: dinky microstepping driver ?