Re: [CAD_CAM_EDM_DRO] please reccomend some DNC software with following protocol

Hi Asim
Try Xlink I think it might be what you are looking for. You can
download a 30 day trial.
http://www.softcncware.com

Illya

----- Original Message -----
From: "Asim Khan" <asimtec@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, September 09, 2003 8:42 PM
Subject: [CAD_CAM_EDM_DRO] please reccomend some DNC software with following
protocol


> Hi group
> I have a cnc milling machine named TRIAC. I need to send program
> block by block to this machine via some dnc software installed on a
> PC via RS232 port. This machine has some special requirement for its
> protocol. It uses three wires Rx Tx and GND for
> its RS232 communication.
>
> The protocol of the machine requires an STX character (0x2) before
> each block and a CR character after the block. The machine starts
> executing the block as soon as the CR character it receives. And The
> machine sends the ACK character (0x6) when it finihes executing the
> block.
>
> Therefor the DNC software must wait for this ACK character before
> sending the next block.
>
> I need some software that can send programs to the machine according
> to this above mentioned protocol.
>
> Please reccomend any DNC software that can be configured to run with
> this protocol.
>
> Best regards
> Asim
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>