RE: [CAD_CAM_EDM_DRO] please reccomend some DNC software with following protocol

Asim

I believe your Triac machine was manufactured by Denford
, a UK based company. Dolphin CAD/CAM software is supplied with
a DNC communications module which supports this machine tool.

Michael

Dolphin CAD CAM Ltd

-----Original Message-----
From: Asim Khan [mailto:asimtec@...]
Sent: 09 September 2003 12:12
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] please reccomend some DNC software with
following protocol

Hi group
I have a cnc milling machine named TRIAC. I need to send program
block by block to this machine via some dnc software installed on a
PC via RS232 port. This machine has some special requirement for its
protocol. It uses three wires Rx Tx and GND for
its RS232 communication.

The protocol of the machine requires an STX character (0x2) before
each block and a CR character after the block. The machine starts
executing the block as soon as the CR character it receives. And The
machine sends the ACK character (0x6) when it finihes executing the
block.

Therefor the DNC software must wait for this ACK character before
sending the next block.

I need some software that can send programs to the machine according
to this above mentioned protocol.

Please reccomend any DNC software that can be configured to run with
this protocol.

Best regards
Asim


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com

Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
Moderator: pentam@... indigo_red@... [Moderators]
URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it
if you have trouble.
http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there,
for OT subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
bill
List Mom
List Owner



Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/