Re: Higher voltage servo motors with low volt drivers
Posted by
Mina Aboul saad
on 2003-09-24 05:34:22 UTC
Thank you for all who tried to answer my thread you've been more than
helpful.
As I understood from Jon Elson's reply, I will not loose any torque if I go
with Gecko320, and the only thing I will be sacrificing is speed, which is
not crucial in this stage for me.
So any suggestions for the DC power supply if I go with Gecko320???
Mina F.
helpful.
As I understood from Jon Elson's reply, I will not loose any torque if I go
with Gecko320, and the only thing I will be sacrificing is speed, which is
not crucial in this stage for me.
So any suggestions for the DC power supply if I go with Gecko320???
Mina F.
> Vince Negrete wrote:reference
>
> >
> >Maybe the other guys can Enlighten me also since I thought Rutex's
> >to Lock Range is really actually called "Error". Right?
> >If you exceed that error limit of +/-128 the driver goes into error and
> >stops. Why set an Error of 30000?
> >Wouldnt this ruin your Product when you find your 0.010" out of spec and
> >your machine didnt even think of erroring???
> >Here is what I'm refering to: http://www.rutex.com/home/servodrv.htm
> >
> >But Rutex comparisons are impressive... I just think that having 30000
> >would actually be a disadvantage.. Right?
> >
> >
> Not necessarily. If the larger following error ocurrs ONLY during rapid
> traverses, and never during cutting moves, it will not affect your parts,
> but allow you to get more speed from the machine during rapid feed.
> This is pretty common practice on commercial gear, and why large
> machine tools have two speed ratings. The lower one is the speed at which
> it maintains some level of accuracy, the higher one is what it can do
> when accuracy is not a concern.
>
> Of course, with step/dir drivers, you are running blind, as you can't
> measure
> the following error from the computer. A true closed-loop system, where
> the encoders feed back to the computer, can allow you to have various
> error bounds at different speeds.
>
> Jon
Discussion Thread
Mina Aboul Saad
2003-09-22 00:28:28 UTC
Higher voltage servo motors with low volt drivers
illya
2003-09-22 04:53:46 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Vince Negrete
2003-09-22 07:47:53 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Jon Elson
2003-09-22 10:59:05 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Jon Elson
2003-09-22 11:04:24 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Vince Negrete
2003-09-23 03:14:06 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Jon Elson
2003-09-23 09:53:27 UTC
Re: [CAD_CAM_EDM_DRO] Higher voltage servo motors with low volt drivers
Mina Aboul saad
2003-09-24 05:34:22 UTC
Re: Higher voltage servo motors with low volt drivers