Re: Have Mecsoft for Mill. Will BobCad work for Lathe?
Posted by
Charles Hixon
on 2003-10-04 07:48:14 UTC
> Does Bobcad (v17, ~$300) do a reasonable job on 2-D lathe CAMusing
> imported DXF? I'm not planning anything complicated and don't wantto
> spend a lot considering the base hardware. I hear great thingsabout
> Dophin but its probably more than I want to spend and I don't needRoger, You will find some very good low end (read free here)
> another mill package.
>
> Any other low end suggestions?
>
> Roger
suggestions if you go back a couple of months review on the Yahoo
MaxNC User Group site. I believe Dolphin is still offering a free
version, don't know what its limitations are. Charles Hixon
Discussion Thread
vrsculptor
2003-10-03 12:49:48 UTC
Have Mecsoft for Mill. Will BobCad work for Lathe?
Charles Hixon
2003-10-04 07:48:14 UTC
Re: Have Mecsoft for Mill. Will BobCad work for Lathe?