Fanuc 11M system, Drip Feed/DNC mode Configuration help needed

Hi Group

Please,
We have a Fanuc 11M Control based Matchmaker Milling Machine. This
machine has limited amount of memory. Therefore It canot run very
large
programs, We want to run this machine in DNC (drip feed mode).

If somebody could tell me the parameter settings related to DNC
in Fanuc11M systems. And how to put the machine in the DNC mode?
Should we select EDIT, MEMO or TAPE mode?
It would be very helpful for us if someone who is been using Fanuc 11M
or similar control in DNC mode, shares this information.

Regards

Asim