RE: [CAD_CAM_EDM_DRO] OFF TOPIC: Clamping stock for milling...?
Posted by
Tim Goldstein
on 2003-10-20 09:16:27 UTC
Just a heads-up. This is primarily an off topic question and as normal
your friendly moderators are not very patient in these matters. Clamps,
clamping strategies, milling procedures to not have your part fall out
prematurely, etc. are all general machining questions and need to be
taken off to an appropriate forum. The only part of the question that is
on topic is how you would define clamping areas in a CAM program.
Any input or comments off list only to
CAD_CAM_EDM_DRO-owner@yahoogroups.com
Tim
[Denver, CO]
your friendly moderators are not very patient in these matters. Clamps,
clamping strategies, milling procedures to not have your part fall out
prematurely, etc. are all general machining questions and need to be
taken off to an appropriate forum. The only part of the question that is
on topic is how you would define clamping areas in a CAM program.
Any input or comments off list only to
CAD_CAM_EDM_DRO-owner@yahoogroups.com
Tim
[Denver, CO]
Discussion Thread
Bill Kichman
2003-10-20 08:17:29 UTC
Clamping stock for milling...?
Tim Goldstein
2003-10-20 09:16:27 UTC
RE: [CAD_CAM_EDM_DRO] OFF TOPIC: Clamping stock for milling...?
Charles Hixon
2003-10-20 14:25:58 UTC
Re: Clamping stock for milling...?