CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Herlp with Sherline Stepper Motor Mounts?

Posted by wanliker@a...
on 2003-11-03 07:54:43 UTC
In a message dated 11/2/2003 9:54:21 PM Mountain Standard Time,
timaga@... writes:
My cross feed is tight; it seems to bind a bit.
I made it a point to move the table completely over next to the mounts before
I tightened the mounts, stops small misalignments in that area. Same when I
tightened the couplers, and mounted the steppers
bill


[Non-text portions of this message have been removed]

Discussion Thread

timaga 2003-11-02 20:52:49 UTC Herlp with Sherline Stepper Motor Mounts? Tim Goldstein 2003-11-02 21:23:45 UTC RE: [CAD_CAM_EDM_DRO] Herlp with Sherline Stepper Motor Mounts? wanliker@a... 2003-11-03 07:54:43 UTC Re: [CAD_CAM_EDM_DRO] Herlp with Sherline Stepper Motor Mounts? wanliker@a... 2003-11-03 07:55:20 UTC Re: [CAD_CAM_EDM_DRO] Herlp with Sherline Stepper Motor Mounts?