Re: 1/2 winding current selection ?
Posted by
turbulatordude
on 2003-11-05 16:44:12 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "John D. Guenther"
<j.guenther@v...> wrote:
If you have 6 or 8 wire motors, you can run in single coil mode which
is full amps, or series at half amps.
read the white paper at http://www.geckodrive.com/
Dave
<j.guenther@v...> wrote:
> I have some Vexta 400 step per rev, 2AMP, 2.25 Ohm, 6 wire motorsHi John,
> that I need to run in 1/2 winding mode. I read something a short
> while ago on one of the groups about reducing the current for this
> mode but I can't seem to locate it. How much should I reduce the
> current for 1/2 winding mode?
>
> Thanks
>
> John Guenther
If you have 6 or 8 wire motors, you can run in single coil mode which
is full amps, or series at half amps.
read the white paper at http://www.geckodrive.com/
Dave
Discussion Thread
John D. Guenther
2003-11-05 09:34:09 UTC
1/2 winding current selection ?
turbulatordude
2003-11-05 16:44:12 UTC
Re: 1/2 winding current selection ?
John Guenther
2003-11-05 19:52:49 UTC
RE: [CAD_CAM_EDM_DRO] Re: 1/2 winding current selection ?
Harvey White
2003-11-05 21:33:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: 1/2 winding current selection ?
turbulatordude
2003-11-06 06:56:22 UTC
Re: 1/2 winding current selection ?