RE: [CAD_CAM_EDM_DRO] Re: PIC Based DRO

That might be true but I sell my dro's with linear glass scales for $695.00
so I guess I have a different logic.

Tim

-----Original Message-----
From: ptengin@... [mailto:ptengin@...]
Sent: Wednesday, April 05, 2000 8:33 PM
To: CAD_CAM_EDM_DRO@egroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Re: PIC Based DRO


In a message dated 04/05/2000 9:49:37 AM Hawaiian Standard Time,
jguenthe@... writes:

<< Let's face it, the logic behind putting an $1800.00 + DRO with linear
scales
on a $500.00 mill or lathe is difficult to comprehend at best.


Regards

John G.

>>

John,
My feeling is, as long as the machine in question is capable of cutting
your part, then the accuracy of the DRO and the operator will be the
determining factor in the quality of a part. As long as it is "square and
plumb", ain't no reason why a low cost milldrill could not turn out very
accurate parts with a good DRO.

Peter
THRD, Inc.

------------------------------------------------------------------------
Get a NextCard Visa, in 30 seconds!
1. Fill in the brief application
2. Receive approval decision within 30 seconds
3. Get rates as low as 2.9% Intro or 9.9% Fixed APR
Apply NOW!
http://click.egroups.com/1/2646/2/_/423600/_/954992019/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager