Re: [cad-cam] RE: [CAD_CAM_EDM_DRO] Re: newbie
Posted by
Harvey White
on 2003-12-05 21:01:47 UTC
On Fri, 5 Dec 2003 09:27:36 -0700, you wrote:
done all three at various times).
I will over-engineer, and put in protection, be it in software or
hardware. It's a matter of personal choice, but I don't regret doing
it this way.
Harvey
(sometimes the diagnostic LEDs and stuff really make life easier, and
that's over-engineering, too...)
>> Well, one very important thing (to me) is opto isolationI am a paranoid engineer/software programmer/systems designer (yeah,
>> between the driving computer and the motor controllers.
>
>I have been using home built CNC machines for about 4 years now. Plenty
>of them have not had any opto isolation and they worked just fine. I
>have never fried a computer or a drive. So while some people consider it
>essential, others are very successful without.
done all three at various times).
I will over-engineer, and put in protection, be it in software or
hardware. It's a matter of personal choice, but I don't regret doing
it this way.
Harvey
(sometimes the diagnostic LEDs and stuff really make life easier, and
that's over-engineering, too...)
>
>Tim
>[Denver, CO]
>Visual Mill 5.0 Basic at a price too low to post!
>
>Sherline & Taig products at Deep Discount
>Mach1 & DeskCNC with credit card ordering
>www.KTMarketing.com/Sherline
>Timg@...
Discussion Thread
edwardhmy@y...
2001-04-06 21:15:48 UTC
newbie
Tim Goldstein
2003-12-05 08:28:10 UTC
RE: [CAD_CAM_EDM_DRO] Re: newbie
Harvey White
2003-12-05 21:01:47 UTC
Re: [cad-cam] RE: [CAD_CAM_EDM_DRO] Re: newbie
lanebarr@b...
2004-01-30 14:39:42 UTC
newbie
Alan Marconett KM6VV
2004-01-30 14:51:57 UTC
Re: [CAD_CAM_EDM_DRO] newbie
james_cullins@s...
2004-01-30 14:59:10 UTC
Re: [CAD_CAM_EDM_DRO] newbie
Dave Fisher
2004-01-30 15:01:16 UTC
RE: [CAD_CAM_EDM_DRO] Shall we buy this ??
Jon Elson
2004-01-30 20:22:08 UTC
Re: [CAD_CAM_EDM_DRO] Shall we buy this ??
Dave Fisher
2004-01-31 02:06:57 UTC
RE: [CAD_CAM_EDM_DRO] Shall we buy this ??
Marcus and Eva
2004-01-31 08:06:22 UTC
Re: [CAD_CAM_EDM_DRO] Shall we buy this ??