emc.ini HELP!!!
Posted by
V Terry Taylor
on 2003-12-12 14:50:28 UTC
could someone help me out with what I need to put in the emc.ini file
for my new sherline 2000 mill (Inch ver) when I got my cd it was bad
so I had to burn a new copy off of the linux supplyers website... But
It is far from configured for my mill... if someone else in this group
has the same mill I would greatly aprecate a coppy of that file... thanks'
for my new sherline 2000 mill (Inch ver) when I got my cd it was bad
so I had to burn a new copy off of the linux supplyers website... But
It is far from configured for my mill... if someone else in this group
has the same mill I would greatly aprecate a coppy of that file... thanks'
Discussion Thread
V Terry Taylor
2003-12-12 14:50:28 UTC
emc.ini HELP!!!
Ray Henry
2003-12-13 07:09:52 UTC
Re: emc.ini HELP!!!