Re: Harbor Freight 47052 to CNC
Posted by
Don Rogers
on 2003-12-15 23:13:17 UTC
At 06:27 AM 12/16/03 +0000, you wrote:
good. However, I pulled out the screw to see about backlash, and how to
mount the motor. I wasn't that pleased with the setup. I later decided to
go with a Taig headstock and make my own rotary table.
If you are interested in one to try, I'll sell you mine for $80 including
shipping and you can have a try. It has never been mounted on a table. No
modifications, other than wiping off the grease.
Don
>has anyone considered or completed a conversion of this rotary table toI purchased one a few months back to convert to a cnc table. It looks very
>cnc?
>
>http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=47052
>
>anyone seen a review or detailed information on this table?
good. However, I pulled out the screw to see about backlash, and how to
mount the motor. I wasn't that pleased with the setup. I later decided to
go with a Taig headstock and make my own rotary table.
If you are interested in one to try, I'll sell you mine for $80 including
shipping and you can have a try. It has never been mounted on a table. No
modifications, other than wiping off the grease.
Don
Discussion Thread
Chris Cowley
2003-12-15 22:27:09 UTC
Harbor Freight 47052 to CNC
Don Rogers
2003-12-15 23:13:17 UTC
Re: Harbor Freight 47052 to CNC
Chris Cowley
2003-12-16 08:56:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Harbor Freight 47052 to CNC
Kenneth A. Emmert
2003-12-16 21:29:13 UTC
RE: Harbor Freight 47052 to CNC
Chris Cowley
2003-12-16 23:06:29 UTC
Re: [CAD_CAM_EDM_DRO] RE: Harbor Freight 47052 to CNC