Bridgeport BOSS conversion
Posted by
cncgramps
on 2003-12-24 18:58:02 UTC
I recently bought a Bridgeport Series 1 with a BOSS4.
I already know I want to upgrade the controller.
I have a smaller mill I converted with servos, Gecko 320's and use
Mach2 software. It works great.
I was wondering if anyone has used Gecko's with the exsisting
stepper motors on a Bridgeport.
If so has it worked out?
Has anyone been able to use the exsiting power supply to run the
steppers with the Gecko drives?
Any feedback on this would be great.
Thanks
Gary
I already know I want to upgrade the controller.
I have a smaller mill I converted with servos, Gecko 320's and use
Mach2 software. It works great.
I was wondering if anyone has used Gecko's with the exsisting
stepper motors on a Bridgeport.
If so has it worked out?
Has anyone been able to use the exsiting power supply to run the
steppers with the Gecko drives?
Any feedback on this would be great.
Thanks
Gary
Discussion Thread
cncgramps
2003-12-24 18:58:02 UTC
Bridgeport BOSS conversion
onecooltoolfool
2003-12-24 19:10:36 UTC
Re: Bridgeport BOSS conversion
washcomp
2003-12-24 20:29:52 UTC
Re: Bridgeport BOSS conversion
cncgramps
2003-12-24 20:40:18 UTC
Re: Bridgeport BOSS conversion
cncgramps
2003-12-24 20:41:16 UTC
Re: Bridgeport BOSS conversion