Gecko 320 pulsing update

Thanks for the help. I was able to change the pins with the software.
Using the setup demo pulsing on the board would not work and the only
way I can make it work is increasing the pulse rate to 8100Hz with
the software. But now using the software which is master5 .the pulse
per inch it will only move .062 when it supposed to move .100 is this
normal to have a high pulse to move The motors are servo dc. when I
tell it to move on the calibration seting They move with no major
problem. Also when the motors are waiting for a command what will
stop that sqealing sound it doesnt do all the time. Thanks Randy