Re: [CAD_CAM_EDM_DRO] Gecko 320 pulsing update
Posted by
Jon Elson
on 2004-01-02 21:28:26 UTC
callcbm2000 wrote:
screws on the back.
If there is a belt reduction, multiply by that value, too.
Multiply by 5 TPI and you have 20,000 counts (steps) per inch.
Jon
>Ok how do you get the cover off the gecko to see where the jumper areYou have to take it off the heat sink. there are two small phillips head
>set?
>
screws on the back.
> Also What is the most Pulse per inch set up typicaly.it is just whatever the encoder counts/rev x leadscrew pitch works out to.
>
If there is a belt reduction, multiply by that value, too.
> It justIf the motor has a 1000 cycle/rev encoder, that gives 4000 counts/rev.
>seem to be high pulses rate just to make it move. the motors are
>mounted direct to a 5 pitch ball screw. Thanks Randy
>
>
Multiply by 5 TPI and you have 20,000 counts (steps) per inch.
Jon
Discussion Thread
callcbm2000
2004-01-02 15:06:06 UTC
Gecko 320 pulsing update
Jon Elson
2004-01-02 15:10:58 UTC
Re: [CAD_CAM_EDM_DRO] Gecko 320 pulsing update
callcbm2000
2004-01-02 16:01:55 UTC
Gecko 320 pulsing update
Jon Elson
2004-01-02 21:28:26 UTC
Re: [CAD_CAM_EDM_DRO] Gecko 320 pulsing update