Re: [CAD_CAM_EDM_DRO] Re: New to Cad/Cam trying to draw in Vector...please help
Posted by
Statman Designs, LLC
on 2004-01-08 07:26:54 UTC
Do you have the free Vector CAD only, or do you have the full CAD/CAM
software? If you do not have the CAM software, you cannot generate the
contour tooling paths. Other than that, I have no suggestions except the
Vector users forum that IMService maintains.
Daniel J. Statman, Statman Designs
www.statmandesigns.com
dan.statman@...
software? If you do not have the CAM software, you cannot generate the
contour tooling paths. Other than that, I have no suggestions except the
Vector users forum that IMService maintains.
Daniel J. Statman, Statman Designs
www.statmandesigns.com
dan.statman@...
----- Original Message -----
From: "kadeshan" <kade@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, January 08, 2004 8:51 AM
Subject: [CAD_CAM_EDM_DRO] Re: New to Cad/Cam trying to draw in
Vector...please help
> Sounds good, now here is another question, I can't find Contour
> Tooling. I looked in the help index, and it doesn't tell you where
> its located. THis is Vector XT. ITs not under draw, curves other.
> THanks
>
>
Discussion Thread
kadeshan
2004-01-07 11:30:03 UTC
New to Cad/Cam trying to draw in Vector...please help
Alan Marconett KM6VV
2004-01-07 13:52:20 UTC
Re: [CAD_CAM_EDM_DRO] New to Cad/Cam trying to draw in Vector...please help
Statman Designs, LLC
2004-01-07 14:03:06 UTC
Re: [CAD_CAM_EDM_DRO] New to Cad/Cam trying to draw in Vector...please help
Michael Milligan
2004-01-07 14:08:22 UTC
RE: [CAD_CAM_EDM_DRO] New to Cad/Cam trying to draw in Vector...please help
kadeshan
2004-01-08 05:52:47 UTC
Re: New to Cad/Cam trying to draw in Vector...please help
Statman Designs, LLC
2004-01-08 07:26:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: New to Cad/Cam trying to draw in Vector...please help
kadeshan
2004-01-08 08:06:18 UTC
Re: New to Cad/Cam trying to draw in Vector...please help
J J Larsen
2004-01-08 08:41:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: New to Cad/Cam trying to draw in Vector...please help
Fred Smith
2004-01-08 08:43:08 UTC
Re: New to Cad/Cam trying to draw in Vector...please help