CAD CAM EDM DRO - Yahoo Group Archive

220 Voltage To Feed Machine Motor and CNC Drives

Posted by brink905
on 2004-01-20 17:21:42 UTC
I've got a Bridgeport machine with a 3 hp motor which is three phase
that I am going run with 220 single phase thru a Hitachi SJ100
inverter. The inverter will convert single phase power to three
phase.

Question that I have can I also use the same 220 single phase line
to feed a 220 power supply that would be used for running Rutex
drivers for the servo motors? Or would it be better to have two
different 220 lines on separate breakers?

Thanks for any information provided,
Dave Brinkman
Yankton, SD

Discussion Thread

brink905 2004-01-20 17:21:42 UTC 220 Voltage To Feed Machine Motor and CNC Drives Jon Elson 2004-01-20 22:07:21 UTC Re: [CAD_CAM_EDM_DRO] 220 Voltage To Feed Machine Motor and CNC Drives Peter Renolds 2004-01-21 07:35:29 UTC Re: [CAD_CAM_EDM_DRO] 220 Voltage To Feed Machine Motor and CNC Drives Jon Elson 2004-01-21 10:18:07 UTC Re: [CAD_CAM_EDM_DRO] 220 Voltage To Feed Machine Motor and CNC Drives Peter Renolds 2004-01-21 12:51:17 UTC Re: [CAD_CAM_EDM_DRO] 220 Voltage To Feed Machine Motor and CNC Drives Gregory Kamysz 2004-01-21 18:02:32 UTC Looking for a link brink905 2004-01-21 18:31:38 UTC Re: Looking for a link brink905 2004-01-21 18:37:57 UTC Re: 220 Voltage To Feed Machine Motor and CNC Drives deanc500 2004-01-21 19:59:34 UTC Re: Looking for a link Gregory Kamysz 2004-01-21 20:17:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Looking for a link