Re: [CAD_CAM_EDM_DRO] Source of linear encoders
Posted by
Lester Caine
on 2004-02-03 05:36:18 UTC
Mcginnis, Darrell S wrote:
that is not a problem.
Thanks for the thoughts.
--
Lester Caine
-----------------------------
L.S.Caine Electronic Services
> These are likely 150 lpi (lines per inch)It's looking like that :)
> I'd suggest looking into optical mouse chips from agilent, they canStill too low, need to be 2000 ( 500 lines per inch )
> supply a native
> 800 cpi (counts per inch) quadrature output for each X and Y.
> If you can find a short linear optical sensor and mount it at a rakedIt's a thought
> angle to a linear
> encoder fence, then you can achieve a good vernier result.
> This would be limited by the frame processing speed on the mouseWe are only looking for lathe and miller feed speeds, so
> chip....2300 frames second
> (translating to a slower "fast slew" limit)
that is not a problem.
Thanks for the thoughts.
--
Lester Caine
-----------------------------
L.S.Caine Electronic Services
Discussion Thread
Lester Caine
2004-02-02 07:26:25 UTC
Source of linear encoders
Mcginnis, Darrell S
2004-02-02 16:37:32 UTC
RE: [CAD_CAM_EDM_DRO] Source of linear encoders
Lester Caine
2004-02-03 05:36:18 UTC
Re: [CAD_CAM_EDM_DRO] Source of linear encoders
Madhu Annapragada
2004-02-03 08:12:41 UTC
RE: [CAD_CAM_EDM_DRO] Source of linear encoders
caudlet
2004-02-03 16:32:45 UTC
Re: Source of linear encoders
Lester Caine
2004-02-04 00:30:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: Source of linear encoders
rdenn25
2004-02-29 15:50:26 UTC
Re: Source of linear encoders
Greg Nuspel
2004-02-29 16:01:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: Source of linear encoders
Terry Owens
2004-02-29 18:53:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: Source of linear encoders
Jon Elson
2004-02-29 20:07:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Source of linear encoders
Sorin Paul
2004-03-01 07:56:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: Source of linear encoders