Re: [CAD_CAM_EDM_DRO] New page
Posted by
Terry Owens
on 2004-02-15 06:55:57 UTC
Hi,
You asy on your site you use a guitar string as the heater, which string the
top E?
Regards.
Terry
You asy on your site you use a guitar string as the heater, which string the
top E?
Regards.
Terry
> Heating the wire is easy. I use a battery charger and light dimmer to heata violin string.
> The CNC part doesn't seem too hard, either. Take a look at this guy'ssite: http://www.buildyouridea.com/cnc/hblb/phase5/phase5.html
Discussion Thread
Ron Thompson
2004-02-14 14:41:55 UTC
New page
Terry Owens
2004-02-15 04:18:57 UTC
Re: [CAD_CAM_EDM_DRO] New page
Ron Thompson
2004-02-15 06:16:17 UTC
Re: [CAD_CAM_EDM_DRO] New page
Greg Nuspel
2004-02-15 06:26:13 UTC
Re: [CAD_CAM_EDM_DRO] New page
Terry Owens
2004-02-15 06:55:57 UTC
Re: [CAD_CAM_EDM_DRO] New page
Ron Thompson
2004-02-15 07:12:36 UTC
Re: [CAD_CAM_EDM_DRO] New page
Bob McKnight
2004-02-15 08:59:08 UTC
Re: [CAD_CAM_EDM_DRO] New page
ballendo
2004-02-15 11:45:05 UTC
cnc foamcutter was Re: New page