Re: [CAD_CAM_EDM_DRO] plasma cutting table - THC
Posted by
Peter Renolds
on 2004-02-20 09:50:05 UTC
Hi Bob,
The reason I asked what controller John was using was exactly because of
your work (and your colleagues) in developing the THC circuit for
Mach2. I know a lot of work went into its development and I may yet
shelve the Flashcut controller (for another project) and setup Mach2 so
I can use your THC design. Depending on John's background, he also may
be better served by considering Mach2 and the already developed THC.
Cheers, Peter
Robert Campbell wrote:
The reason I asked what controller John was using was exactly because of
your work (and your colleagues) in developing the THC circuit for
Mach2. I know a lot of work went into its development and I may yet
shelve the Flashcut controller (for another project) and setup Mach2 so
I can use your THC design. Depending on John's background, he also may
be better served by considering Mach2 and the already developed THC.
Cheers, Peter
Robert Campbell wrote:
>John,
>
>
>
>
>
Discussion Thread
johnong23
2004-02-19 23:39:28 UTC
plasma cutting table?
Peter Renolds
2004-02-20 06:08:42 UTC
Re: [CAD_CAM_EDM_DRO] plasma cutting table?
Robert Campbell
2004-02-20 06:43:51 UTC
Re: [CAD_CAM_EDM_DRO] plasma cutting table?
Peter Renolds
2004-02-20 09:50:05 UTC
Re: [CAD_CAM_EDM_DRO] plasma cutting table - THC
Ong John
2004-02-21 18:33:56 UTC
Re: [CAD_CAM_EDM_DRO] plasma cutting table?
Peter Renolds
2004-02-22 13:27:36 UTC
Re: [CAD_CAM_EDM_DRO] plasma cutting table?