Re: [CAD_CAM_EDM_DRO] Newbie needs servo help
Posted by
Jon Elson
on 2004-03-03 22:06:23 UTC
INDECO wrote:
Are these brushless motors? You could be in trouble with this,
as low-cost brushless drives are rare. The lowest-cost unit I know
of is the Rutex R992H.
Jon
>Hello,You just have the servo motors, no servo driver or servo amp?
>
> I have a 5 wire stepper motor that I need help with wiring.
>I also have 2 Aerotec 1000 series servo I need help with.
>I have pictures of the servo I can send someone.
>
>
Are these brushless motors? You could be in trouble with this,
as low-cost brushless drives are rare. The lowest-cost unit I know
of is the Rutex R992H.
Jon
Discussion Thread
INDECO
2004-03-03 16:08:08 UTC
Newbie needs servo help
Jon Elson
2004-03-03 22:06:23 UTC
Re: [CAD_CAM_EDM_DRO] Newbie needs servo help
INDECO
2004-03-04 04:21:05 UTC
Re: [CAD_CAM_EDM_DRO] Newbie needs servo help
INDECO
2004-03-04 04:25:02 UTC
Re: [CAD_CAM_EDM_DRO] Newbie needs servo help
Ed Gilbert
2004-03-04 05:20:10 UTC
RE: [CAD_CAM_EDM_DRO] Newbie needs servo help
Jon Elson
2004-03-04 10:32:05 UTC
Re: [CAD_CAM_EDM_DRO] Newbie needs servo help
rockinwood_2000
2004-03-04 10:51:55 UTC
Re: Newbie needs servo help
INDECO
2004-03-04 11:14:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie needs servo help
Raymond Heckert
2004-03-04 18:56:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie needs servo help
Jon Elson
2004-03-04 22:23:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie needs servo help
Jon Elson
2004-03-04 22:24:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie needs servo help