CAD CAM EDM DRO - Yahoo Group Archive

Re: Yaskawa Servo Pack/Motor compatibility

Posted by vrsculptor
on 2004-03-09 05:57:13 UTC
> Thanks for the tip, but it won't work. From the webpage: "The
index
> signal from the encoder is simply passed straight through from
input
> to output with no change."
>
> These motor have a special index (encoder C phase) signal, that
also
> has to be processed for this to work.
>
Arvid,
Bummer. Never ran into a 3 phase encoder. You can build your own
divide by 2 circuit for all 3 phases using 2 edge triggered flip
flops (74F74 ~$0.35). See
http://physics.uoregon.edu/~torrence/432/notes/notes4.pdf
You would have to do a reset at power on with a simple RC circuit to
insure counter phases.

Roger

Discussion Thread

bitnick78 2004-03-08 12:23:36 UTC Yaskawa Servo Pack/Motor compatibility Hartono Setiono 2004-03-08 14:54:13 UTC Re: [CAD_CAM_EDM_DRO] Yaskawa Servo Pack/Motor compatibility vrsculptor 2004-03-08 16:03:46 UTC Re: Yaskawa Servo Pack/Motor compatibility bitnick78 2004-03-09 01:48:04 UTC Re: Yaskawa Servo Pack/Motor compatibility Erie Patsellis 2004-03-09 05:37:30 UTC Re: [CAD_CAM_EDM_DRO] Re: Yaskawa Servo Pack/Motor compatibility vrsculptor 2004-03-09 05:57:13 UTC Re: Yaskawa Servo Pack/Motor compatibility bitnick78 2004-03-09 10:46:41 UTC Re: Yaskawa Servo Pack/Motor compatibility