Re: Helix Angle
Posted by
rawen2
on 2004-03-09 18:07:51 UTC
Wait a minute, I think I goofed. The angle would be half what I
figured due to the fact that the thread would only angle half the
pitch on one side of the diameter.
So instead of 10.003 it would be 5.0015 degrees. I think....Geez,
next time maybe I'll let someone else speak up first!
Ralph Wenzl
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Terry Owens" <terry@o...>
wrote:
figured due to the fact that the thread would only angle half the
pitch on one side of the diameter.
So instead of 10.003 it would be 5.0015 degrees. I think....Geez,
next time maybe I'll let someone else speak up first!
Ralph Wenzl
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Terry Owens" <terry@o...>
wrote:
> Hi,to know
>
> This may at first sight appaer to be off-topic but it isn't. I nned
> the answer so I can draw it in CAD to make a part for a CNC machine.in it
>
> If I had a piece of round bar 18mm (0.7087") and cut an 8TPI thread
> how would I work out the helix angle of the thread?
>
> Regards,
>
> Terry
Discussion Thread
Terry Owens
2004-03-09 15:09:11 UTC
Helix Angle
rawen2
2004-03-09 17:14:53 UTC
Re: Helix Angle
rawen2
2004-03-09 17:22:03 UTC
Re: Helix Angle
rawen2
2004-03-09 18:07:51 UTC
Re: Helix Angle
Kevin Martin
2004-03-09 18:58:06 UTC
RE: [CAD_CAM_EDM_DRO] Helix Angle
Raymond Heckert
2004-03-09 19:13:23 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Terry Owens
2004-03-10 09:26:02 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Terry Owens
2004-03-10 09:48:48 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
david_margrave
2004-03-10 10:58:20 UTC
Re: Helix Angle
John Johnson
2004-03-10 12:50:53 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Marcus
2004-03-10 17:57:44 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Raymond Heckert
2004-03-10 20:09:35 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Terry Owens
2004-03-11 07:36:26 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
ballendo
2004-03-11 09:09:45 UTC
motor couplers was Re: Helix Angle
Raymond Heckert
2004-03-11 20:30:43 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle
Raymond Heckert
2004-03-11 20:30:44 UTC
Re: [CAD_CAM_EDM_DRO] Helix Angle