CAD CAM EDM DRO - Yahoo Group Archive

Re: rookie needs help

Posted by Jens Swales
on 2004-03-21 11:29:32 UTC
hi again

please join the fc group, im sure we can work this out...
http://groups.yahoo.com/group/flashcutcnc/

jens









--- In CAD_CAM_EDM_DRO@yahoogroups.com, "djamer88" <dennisf38@a...>
wrote:
> First thanks to all for any help, I have the Flash cut system and
> Have it installed on the PC side and it's working, I am trying to
use
> it on an Orac Denford lathe using it's original PKS Digiplan drives
> and MAE stepper motor's the drives do not need an enable line as
they
> are hot with power turned on both drives are holding position, I
did
> have the Z stepper jog from the jog control on the PC screen but I
> had the line in a temporary connection and when I made it a more
> permanent connection and hooked up the X dive and retried the
system
> it would not jog again I have double checked the connection drives
> are hot grounds are good but no Jog control any help is appreciated.
>
> Brg's
> Dennis

Discussion Thread

djamer88 2004-03-20 13:07:02 UTC rookie needs help Jens Swales 2004-03-20 14:08:52 UTC Re: rookie needs help djamer88 2004-03-20 15:07:22 UTC Re: rookie needs help Jens Swales 2004-03-21 11:29:32 UTC Re: rookie needs help