Re: radius...diameter
Posted by
bull2002winkle
on 2004-03-21 19:42:13 UTC
Yes, this is correct. TCNC believes what you tell it about steps/in.
(or steps/mm).
Ken
(or steps/mm).
Ken
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Torsten" <torsten@g...> wrote:
> I am not sure but I wonder if you
> could just setup with a stepdistance
> of twice as what it is now?
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "motorworksnf"
> <motorworksnf@y...> wrote:
> >
> >
> >
> > Hi
> > I am using turbo to run a lathe I convered.
> > On the x axis the program now works in the radius mode.
> > Is there any way to have this in a diameter mode.
> > ie Right now I program in Radius, but I would like to use Diameter.
> > e
Discussion Thread
motorworksnf
2004-03-21 08:50:29 UTC
radius...diameter
Torsten
2004-03-21 17:18:03 UTC
Re: radius...diameter
bull2002winkle
2004-03-21 19:42:13 UTC
Re: radius...diameter
Gregory Kamysz
2004-03-23 22:01:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: radius...diameter
Torsten
2004-03-24 06:09:28 UTC
Re: radius...diameter