Re: [CAD_CAM_EDM_DRO] Re: radius...diameter

But if you lie to it about the step distance what happens when you try
to cut a 45 degree chamfer? That may be easier to work around than
trying to put a radius on a part.

Greg


bull2002winkle wrote:

> Yes, this is correct. TCNC believes what you tell it about steps/in.
> (or steps/mm).
>
> Ken
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Torsten" <torsten@g...> wrote:
>
>>I am not sure but I wonder if you
>>could just setup with a stepdistance
>>of twice as what it is now?
>>
>>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "motorworksnf"
>><motorworksnf@y...> wrote:
>>
>>>
>>>
>>>Hi
>>>I am using turbo to run a lathe I convered.
>>>On the x axis the program now works in the radius mode.
>>>Is there any way to have this in a diameter mode.
>>>ie Right now I program in Radius, but I would like to use Diameter.
>>>e
>
>
>