Re: radius...diameter
Posted by
Torsten
on 2004-03-24 06:09:28 UTC
You would not be lying to it, just have to make
sure the commands you program are diameter dimensions
for all x moves.
This should work for radiuses also but you will have
to try it out first some controllers will not
allow different resolutions for circular interpolation.
Good Luck
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Gregory Kamysz
<smsupply@a...> wrote:
sure the commands you program are diameter dimensions
for all x moves.
This should work for radiuses also but you will have
to try it out first some controllers will not
allow different resolutions for circular interpolation.
Good Luck
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Gregory Kamysz
<smsupply@a...> wrote:
> But if you lie to it about the step distance what happens when youtry
> to cut a 45 degree chamfer? That may be easier to work around thansteps/in.
> trying to put a radius on a part.
>
> Greg
>
>
> bull2002winkle wrote:
> > Yes, this is correct. TCNC believes what you tell it about
> > (or steps/mm).wrote:
> >
> > Ken
> >
> > --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Torsten" <torsten@g...>
> >Diameter.
> >>I am not sure but I wonder if you
> >>could just setup with a stepdistance
> >>of twice as what it is now?
> >>
> >>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "motorworksnf"
> >><motorworksnf@y...> wrote:
> >>
> >>>
> >>>
> >>>Hi
> >>>I am using turbo to run a lathe I convered.
> >>>On the x axis the program now works in the radius mode.
> >>>Is there any way to have this in a diameter mode.
> >>>ie Right now I program in Radius, but I would like to use
> >>>e
> >
> >
> >
Discussion Thread
motorworksnf
2004-03-21 08:50:29 UTC
radius...diameter
Torsten
2004-03-21 17:18:03 UTC
Re: radius...diameter
bull2002winkle
2004-03-21 19:42:13 UTC
Re: radius...diameter
Gregory Kamysz
2004-03-23 22:01:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: radius...diameter
Torsten
2004-03-24 06:09:28 UTC
Re: radius...diameter