Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Posted by
Ward M.
on 2000-04-18 22:24:59 UTC
Thanks Tim, I'll install it tonight. To install different versions, do you
install one over another, or create a new directory tree for it?
Ward M.
ward@...
install one over another, or create a new directory tree for it?
Ward M.
ward@...
----- Original Message -----
From: "Tim Goldstein" <timg@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, April 18, 2000 9:55 PM
Subject: RE: [CAD_CAM_EDM_DRO] Which version of EMC?
> I have found the 15-Mar-2000 version to be much better than the December
> version for steppers. I think that Jon Elson is happier with the December
> version for his servo setup. It is not very hard to install the different
> versions (just make sure your .run and .ini for each version is saved). I
> would start with the most recent if you are looking to test with steppers.
>
> Tim
> [Denver, CO]
>
Discussion Thread
Ward M.
2000-04-18 22:24:59 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Ward M.
2000-04-19 19:06:00 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Tim Goldstein
2000-04-19 19:53:14 UTC
RE: [CAD_CAM_EDM_DRO] Which version of EMC?
Tim Goldstein
2000-04-21 08:24:39 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Dan Falck
2000-04-21 09:14:53 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Tim Goldstein
2000-04-24 06:13:30 UTC
RE: [CAD_CAM_EDM_DRO] Which version of EMC?
Matt Shaver
2000-04-24 07:11:22 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?