Re: EMC & Linux
Posted by
Tim Goldstein
on 1999-06-10 21:35:30 UTC
If you are running steppers on the build date 08-jun-1999 you now have to
configure a parameter called CYCLE_TIME. I was a little confused on this
setting so I called Fred today and again took the time to set me straight.
To make it easier to figure out a value to use as a starting point I have
put a web page at http://web1.ktmarketing.com/tim/EMCCalc.asp that will give
you the appropriate value for CYCLE_TIME and MAX_VELOCITY if you have EMC
configured to use inches based upon the steps per inch and the maximum speed
your machine is capable of in inches per minute.
Tim
[Denver, CO]
configure a parameter called CYCLE_TIME. I was a little confused on this
setting so I called Fred today and again took the time to set me straight.
To make it easier to figure out a value to use as a starting point I have
put a web page at http://web1.ktmarketing.com/tim/EMCCalc.asp that will give
you the appropriate value for CYCLE_TIME and MAX_VELOCITY if you have EMC
configured to use inches based upon the steps per inch and the maximum speed
your machine is capable of in inches per minute.
Tim
[Denver, CO]
Discussion Thread
Tim Goldstein
1999-06-05 18:25:05 UTC
EMC & Linux
Dan Falck
1999-06-05 20:35:19 UTC
Re: EMC & Linux
Matt Shaver
1999-06-05 20:36:55 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-05 21:27:59 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-05 23:01:59 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-05 23:02:12 UTC
Re: EMC & Linux
Jon Elson
1999-06-05 23:19:08 UTC
Re: EMC & Linux
Matt Shaver
1999-06-05 23:17:16 UTC
Re: EMC & Linux
Jon Elson
1999-06-05 23:24:21 UTC
Re: EMC & Linux
Ron Wickersham
1999-06-05 23:54:02 UTC
Re: EMC & Linux
Matt Shaver
1999-06-06 01:27:36 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-06 12:59:54 UTC
Re: EMC & Linux
Jon Elson
1999-06-06 17:09:30 UTC
Re: EMC & Linux
Mo
1999-06-06 21:14:47 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-06 22:57:15 UTC
Re: EMC & Linux
Jon Elson
1999-06-06 23:33:23 UTC
Re: EMC & Linux
TADGUNINC@x...
1999-06-07 07:04:44 UTC
Re: EMC & Linux
Tim Goldstein
1999-06-10 21:35:30 UTC
Re: EMC & Linux