Re: camtronics driver

Dan,

Is the case you are using an off the shelf unit or do you make it? I hunted
all over and the only enclosure I could find that was at least that big was
designed to mount in a 19" rack unit and cost around $120. I ended up making
my own case out of masonite with a particle board base.


Tim
[Denver, CO]

> -----Original Message-----
> From: Dan Mauch [mailto:dmauch@...]
> Sent: Thursday, June 10, 1999 6:46 AM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: Re: [CAD_CAM_EDM_DRO] camtronics driver
>
>
> From: "Dan Mauch" <dmauch@...>
>
> On my 5 amp controller I place everything in a 12X10X6 case . The fan was
> mounted on the outside of the case and the transformers are located inside
> the case. The transformers are on one side of the case and the drivers are
> on the other. No problems with noise.
> Dan
> -----Original Message-----
> From: Al Schoepp <aschoepp@...>
> To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
> Date: Wednesday, June 09, 1999 6:11 PM
> Subject: [CAD_CAM_EDM_DRO] camtronics driver
>
>
> >From: Al Schoepp <aschoepp@...>
> >
> >Just curious, I'm in the process of constructing on of Dan's 5A stepper
> >drivers and was wondering if it's ok to put the transformer/power supply
> >components in the same enclosure. I'm new to all of this stuff and was
> >wondering if the AC current in the enclosure would end up creating a lot
> >of noise that would affect the stepper driver operation.
> >
> >Thanks,
> >Al
> >
> >------------------------------------------------------------------------
> >Campaign 2000 is here!
> >http://www.onelist.com
> >Discuss your thoughts; get informed at ONElist. See our homepage.
> >------------------------------------------------------------------------
> >welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
> discussion of shop built systems in the above catagories.
> >
>
>
> ------------------------------------------------------------------------
> What do lizards and rock music have in common?
> http://www.onelist.com
> They both have communities at ONElist. Find yours today!
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for
> the discussion of shop built systems in the above catagories.
>