CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Resolution

Posted by Nick Ibbitson
on 2004-05-01 09:53:32 UTC
its fine for turbocnc but too low i think for mach 2. I use both.

Nick
----- Original Message -----
From: "Terry Owens" <terry@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, April 30, 2004 9:47 PM
Subject: [CAD_CAM_EDM_DRO] Resolution


> Hi,
>
> I've just bought a flat screen 10" colour monitor but its max resolution
is
> 640 x 480 is this high enough to run TurboCNC or Mach2?
>
> Regards,
>
> Terry
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... davemucha@...
[Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>
>

Discussion Thread

Terry Owens 2004-04-30 13:45:39 UTC Resolution bull2002winkle 2004-04-30 14:22:21 UTC Re: Resolution Nick Ibbitson 2004-05-01 09:53:32 UTC Re: [CAD_CAM_EDM_DRO] Resolution Terry Owens 2004-05-01 18:03:41 UTC Re: [CAD_CAM_EDM_DRO] Resolution Gregory Kamysz 2004-05-01 19:20:06 UTC My mill project Scott A. Stephens 2004-05-02 07:18:38 UTC Re: [CAD_CAM_EDM_DRO] My mill project Alan Marconett KM6VV 2004-05-02 12:41:50 UTC Re: [CAD_CAM_EDM_DRO] My mill project Gregory Kamysz 2004-05-02 14:27:41 UTC Re: [CAD_CAM_EDM_DRO] My mill project