Re: [CAD_CAM_EDM_DRO] Techno 4- Axis SD Motherboard

I have done this before. The people from Digipan/Compumotor faxed me the
info showing where the step and direction signals should go. I will try to
dig the paperwork out this weekend.

Dan

At 03:25 PM 4/21/00 -0700, you wrote:

>I'm converting an old Techno Isel router over to CNC Pro. Has anyone
>converted a Techno SD motherboard over to straight step and direction
>inputs and skipped the PCMAC controller? The motherboard is set up to
>take step and direction inputs, but the pin outs on the connector has
>been a little hard to decipher. Any comments or suggestions?
>
>
>Thanks
>
>Thomas Akers
>AeroMech
>Los Osos, CA
>
>
>------------------------------------------------------------------------
>You can never start too early, or too late. Education is
>the key to a healthy future for our planet. ENN provides
>the materials to teach others to protect our environment
>and understand why it's important.
>http://click.egroups.com/1/2795/2/_/423600/_/956355658/
>------------------------------------------------------------------------
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>