Re: [CAD_CAM_EDM_DRO] Linking stepper motors together.
Posted by
testfly@a...
on 2004-05-09 13:25:02 UTC
Using Turbocnc software and driver/stepper motors from HobbyCNC. 4 motor 125 oz
I am trying to get the A and X motors to work the same so I can use them on a hot wire foam cutting system. I am only able to do this so far by added the A code to the X code lines. Now I have them working together but hoping for a faster way.
Any ideas? Can they be linked some how to work together as one in the software?
Thanks in advance!
[Non-text portions of this message have been removed]
I am trying to get the A and X motors to work the same so I can use them on a hot wire foam cutting system. I am only able to do this so far by added the A code to the X code lines. Now I have them working together but hoping for a faster way.
Any ideas? Can they be linked some how to work together as one in the software?
Thanks in advance!
[Non-text portions of this message have been removed]
Discussion Thread
testfly@a...
2004-05-09 13:25:02 UTC
Re: [CAD_CAM_EDM_DRO] Linking stepper motors together.
caudlet
2004-05-09 16:13:23 UTC
Re: Linking stepper motors together.