Re: [CAD_CAM_EDM_DRO] Producing G code from a scan
Posted by
Yesamazza@a...
on 2004-05-19 16:43:02 UTC
I have a couple of things to add to the answer previously posted
I would use mastercam to "clean up" the DXF from corel if I was going to do
more then one or wanted real clean edges. When you cut a dxf that is rough it
takes longer and the quality is low generally. You can take the dxf file and
do a connect the dots spline which takes more time to create the file but
speeds up the manufacturing.
[Non-text portions of this message have been removed]
I would use mastercam to "clean up" the DXF from corel if I was going to do
more then one or wanted real clean edges. When you cut a dxf that is rough it
takes longer and the quality is low generally. You can take the dxf file and
do a connect the dots spline which takes more time to create the file but
speeds up the manufacturing.
[Non-text portions of this message have been removed]
Discussion Thread
garagefella
2004-05-19 11:48:23 UTC
Producing G code from a scan
caudlet
2004-05-19 13:09:04 UTC
Re: Producing G code from a scan
Dave Hylander
2004-05-19 13:46:08 UTC
Re: [CAD_CAM_EDM_DRO] Producing G code from a scan
Bob McKnight
2004-05-19 14:07:28 UTC
Re: [CAD_CAM_EDM_DRO] Producing G code from a scan
caudlet
2004-05-19 16:29:06 UTC
Re: Producing G code from a scan
caudlet
2004-05-19 16:39:19 UTC
Re: Producing G code from a scan
Yesamazza@a...
2004-05-19 16:43:02 UTC
Re: [CAD_CAM_EDM_DRO] Producing G code from a scan
Bob McKnight
2004-05-19 17:10:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: Producing G code from a scan
Bob McKnight
2004-05-19 17:10:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Producing G code from a scan
caudlet
2004-05-19 17:41:54 UTC
Re: Producing G code from a scan
Alan Marconett
2004-05-19 18:18:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Producing G code from a scan
Bob McKnight
2004-05-19 19:30:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Producing G code from a scan
hal_eckhart
2004-05-19 20:32:38 UTC
Re: HPGL plotters (was Producing G code...)
Alan Marconett
2004-05-20 10:40:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: HPGL plotters (was Producing G code...)