Re: Need advice: MaxNC or Sherline or other or nothing

Do you know of any good plans or sets of drawings out there for a
benchtop sized mill? I have thought before about fabricating
everything from scratch, but I fear that there would be too many
mechanical details I mightn't be able to get right (gibbs, spindle),
along with the difficulty of wiring up all the servo drivers (I
suppose I should use Gecko drives?)

Thanks,
Andrew

>
> [If you're up to fabricating things on a Fadal, then I think you'd

be better

> off designing and building a mill from scratch; you'd end up with

just what

> you wanted, not a kludge of your parts and another solution's

inherited

> problems.]
>