Re: Need advice: MaxNC or Sherline or other or nothing
Posted by
notoneleft
on 2004-06-25 05:43:52 UTC
Check out http://www.5bears.com
Gerry
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "CrazyDudeII" <apullin@h...>
wrote:
Gerry
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "CrazyDudeII" <apullin@h...>
wrote:
> Do you know of any good plans or sets of drawings out there for aspindle),
> benchtop sized mill? I have thought before about fabricating
> everything from scratch, but I fear that there would be too many
> mechanical details I mightn't be able to get right (gibbs,
> along with the difficulty of wiring up all the servo drivers (Iyou'd
> suppose I should use Gecko drives?)
>
> Thanks,
> Andrew
>
> >
> > [If you're up to fabricating things on a Fadal, then I think
> be better
> > off designing and building a mill from scratch; you'd end up with
> just what
> > you wanted, not a kludge of your parts and another solution's
> inherited
> > problems.]
> >
Discussion Thread
CrazyDudeII
2004-06-22 09:39:59 UTC
Need advice: MaxNC or Sherline or other or nothing
afogassa
2004-06-22 16:36:49 UTC
Re: Need advice: MaxNC or Sherline or other or nothing
Andrew Werby
2004-06-23 13:05:56 UTC
Re: Need advice: MaxNC or Sherline or other or nothing
Jason Spangle
2004-06-24 23:00:04 UTC
Re: Need advice: MaxNC or Sherline or other or nothing
CrazyDudeII
2004-06-24 23:00:05 UTC
Re: Need advice: MaxNC or Sherline or other or nothing
Peter Homann
2004-06-25 00:58:24 UTC
RE: [CAD_CAM_EDM_DRO] Re: Need advice: MaxNC or Sherline or other or nothing
notoneleft
2004-06-25 05:43:52 UTC
Re: Need advice: MaxNC or Sherline or other or nothing
CrazyDudeII
2004-07-02 16:44:30 UTC
Re: Need advice: MaxNC or Sherline or other or nothing