EMC problem processing Vector G-code

So when I put in this code to the EMC:
N31 G01 X0.219 Y-0.250 F0.9
N32 G03 X-0.250 Y0.219 I-0.469 J0.000
N33 G01 X-4.123 Y0.219
N34 G03 X-4.492 Y0.040 I0.000 J-0.469
N35 G01 X-4.917 Y-0.501
N36 G02 X-5.310 Y-0.693 I-0.393 J0.309
N37 G01 X-7.521 Y-0.693
N38 G03 X-7.740 Y-0.912 I0.000 J-0.219
N39 G01 X-7.740 Y-1.412
N40 G03 X-7.521 Y-1.631 I0.219 J0.000
N41 G01 X-7.271 Y-1.631
N42 G02 X-7.240 Y-1.662 I0.000 J-0.031
N43 G01 X-7.240 Y-2.593
N44 G03 X-6.771 Y-3.062 I0.469 J0.000
N45 G01 X-5.256 Y-3.062
N46 G02 X-5.095 Y-3.112 I0.000 J-0.281
N47 G01 X-4.440 Y-3.569
N48 G03 X-4.171 Y-3.653 I0.268 J0.385
N49 G01 X-0.250 Y-3.653
N50 G03 X0.219 Y-3.184 I0.000 J0.469
N51 G01 X0.219 Y-0.250

I get a "radius to end of arc differs from radius to start of arc..."
How do I get Vector to correct the arc so that EMC will run it, or
what do I have to adjust in the emc.ini ?