CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] bridgeport stepper motor specs - help

Posted by Les Newell
on 2004-07-20 01:22:52 UTC
Geckos are a bit undersized for Bridgeport motors. To get decent feed
rates run them at full current (no resistor) and the highest supply
voltage possible. Also run the motors in half winding mode:

2 connected to phase A+
8 connected to phase A-
1 connected to phase B+
6 connected to phase B-
The other terminals are left unconnected.

With Geckos set to full current and with a 75V supply I get reliable
2.4m/min (96IPM) rapids and plenty of torque.


Les


theokspindoctor wrote:
> I am having my Bridgeport Boss 6 mill rebuilt. The man I hired must
> know how much current the stepper motors draw in order to properly
> fit the resistor required on the Gecko 201 drives we are trying to
> install. I think they are Superior motors but cannot find out the
> specs in the Bridgeport manual or schematics. Does anyone have any
> help for me? or where I can go to find out. thanks
>
> Keith Clark
> clarkfamily5@...
>
>

Discussion Thread

theokspindoctor 2004-07-19 21:27:25 UTC bridgeport stepper motor specs - help Les Newell 2004-07-20 01:22:52 UTC Re: [CAD_CAM_EDM_DRO] bridgeport stepper motor specs - help JanRwl@A... 2004-07-20 15:12:33 UTC Re: [CAD_CAM_EDM_DRO] bridgeport stepper motor specs - help theokspindoctor 2004-07-20 15:14:55 UTC Re: bridgeport stepper motor specs - help metlmunchr 2004-07-20 16:27:13 UTC Re: bridgeport stepper motor specs - help washcomp 2004-07-20 16:58:54 UTC Re: bridgeport stepper motor specs - help Raymond Heckert 2004-07-20 19:56:24 UTC Re: [CAD_CAM_EDM_DRO] bridgeport stepper motor specs - help Keith Clark 2004-08-21 09:33:56 UTC Re: bridgeport stepper motor specs - help washcomp 2004-08-21 11:48:37 UTC Re: bridgeport stepper motor specs - help Keith Clark 2004-08-21 12:30:53 UTC Re: bridgeport stepper motor specs - help washcomp 2004-08-21 12:37:24 UTC Re: bridgeport stepper motor specs - help Keith Clark 2004-08-21 12:39:13 UTC Re: bridgeport stepper motor specs - help