CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] the mc3479p ic?

Posted by James Cullins
on 2000-05-03 06:02:06 UTC
Use www.Findchips.com to get the data sheets on it. I believe this chip is
only good for
about 350ma per coil.
Jim
----- Original Message -----
From: Derek Barger <hightechsystems@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, May 02, 2000 9:29 PM
Subject: [CAD_CAM_EDM_DRO] the mc3479p ic?


Hi fellow listers,

Question has anyone used this ic in a bipolar stepper drive to drive 5A
loads?
Any pc-board examples out there?
Anyone used this with EMC?

Derek

------------------------------------------------------------------------
Get paid for the stuff you know!
Get answers for the stuff you don't. And get $10 to spend on the site!
http://click.egroups.com/1/2200/2/_/423600/_/957321273/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager

Discussion Thread

James Cullins 2000-05-03 06:02:06 UTC Re: [CAD_CAM_EDM_DRO] the mc3479p ic? Derek Barger 2000-05-03 06:39:44 UTC Re: [CAD_CAM_EDM_DRO] the mc3479p ic? James Cullins 2000-05-03 20:16:14 UTC Re: [CAD_CAM_EDM_DRO] the mc3479p ic?