Re: [CAD_CAM_EDM_DRO] the mc3479p ic?

James:
I do have the data sheets the 350ma is direct drive from the chip itself
to the motor. Transistors can change this to a 5A drive. All the other
chip makers that say they drive 5A, don't directly you have to add
transistors.

Derek

James Cullins wrote:

>
> Use www.Findchips.com to get the data sheets on it. I believe this chip is
> only good for
> about 350ma per coil.
> Jim
> ----- Original Message -----
> From: Derek Barger <hightechsystems@...>
> To: <CAD_CAM_EDM_DRO@egroups.com>
> Sent: Tuesday, May 02, 2000 9:29 PM
> Subject: [CAD_CAM_EDM_DRO] the mc3479p ic?
>
> Hi fellow listers,
>
> Question has anyone used this ic in a bipolar stepper drive to drive 5A
> loads?
> Any pc-board examples out there?
> Anyone used this with EMC?
>
> Derek
>
> ------------------------------------------------------------------------
> Get paid for the stuff you know!
> Get answers for the stuff you don't. And get $10 to spend on the site!
> http://click.egroups.com/1/2200/2/_/423600/_/957321273/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
> ------------------------------------------------------------------------
> SHOPPING for DEALS? The merchants at BuyItOnline.com are offering up
> to 30% OFF great gear, wear, gadgets and more, now through April 15,
> 2000. Real stores. Real Deals. Real Easy. Go get something great!
> http://click.egroups.com/1/3025/2/_/423600/_/957358926/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager